The Robird, designed to chase away nuisance birds.. Autonomously!

Nowadays robots appear in all kinds of shapes. After we already mentioned the robotic roach it’s now time for the Robird.

Robird is a robotic peregrine falcon that will be used to chase away birds at airports and waste-processing sites. The Robird is now operated manually, but must ultimately be able to fly and dispel birds autonomously. With the assistance of the European Space Agency ESA, robotics researchers at the University of Twente have taken an essential step toward the Robird’s completely autonomous flight.


The researchers were successful in modelling the complete dynamics and mechanics of a flapping wing in a computer simulation – this, in order to steer the Robird more effectively and accurately with the electronics. To date, during the transition from manual steering to complete autonomy, only subsystems in the Robird were able to be modelled, and not a complete, moving wing. The combination of the model used, along with measurements in a wind tunnel and in a vacuum chamber, is unique in science.

“An autonomous Robird is a huge step forward,” said master’s student Berend van der Grinten, “but it’s extremely difficult to visualise the play of forces in the wings. The standard models for 3-D aerodynamics (FEM) require considerable computing power and can’t be applied to the electronics or to command and control”.

To combine everything into a single model, Van der Grinten set about working with PhD candidate Geert Folkertsma in a revolutionary way. The robotic bird’s ‘actual’ wing behaviour was measured in 3-D using two cameras and a stroboscope for delaying the motion. “A clever approach. This allowed us to film much more rapidly with relatively cheap cameras.”

The wing motion was measured in the Technical Track faculty’s wind tunnel at the University of Twente and in the vacuum chamber at ESA’s ESTEC facility in Noordwijk. “There is no air in the vacuum chamber, so there are no aerodynamic forces, either. By measuring the flapping wing in both the wind tunnel and the vacuum chamber, the motion attributable to aerodynamics can be calculated precisely by means of subtraction. This is an essential fact. Measuring in the vacuum chamber was not easy. The sublimation of materials is a problem: this can contaminate the vacuum chamber. Special glue, tape and gaskets had to be used. There was also the risk that the cameras or motors would heat up and therefore fail. Since there is no air in a vacuum chamber, the most important cooling had to be done by means of conduction from the material. Fortunately, we found solutions to everything and encountered no problems with the measurements.


Clear Flight Solution

The Robird is the flagship product of Clear Flight Solution, a robotics and drones spin-off from the University of Twente. The company recently received an investment of 1.6 million euro from the Cottonwood Euro Technology Fund. With this investment, Clear Flight Solutions wishes to grow into the position of the world’s largest bird-threat regulation company. The damage caused by birds at airports worldwide – material damage and otherwise – is estimated to be in the billions. The nuisance caused by birds also occasionally results in fatal accidents. Furthermore, birds cause billions of damage worldwide in the agricultural sector, in the waste-processing sector, in harbours and in the oil and gas industry. One known problem is that birds are intelligent and get used to existing solutions to bird-threat management: they simply fly around them. The Robird, which realistically simulates the flight of a peregrine falcon, is a new, high-tech solution. The flight behaviour of the “Robird” is so realistic that birds believe that their natural enemy is present in the vicinity. This approach plays on a bird’s fears, so habituation is no longer a problem.


Categories: 3D Printing,Robotica

Comments are closed